Basically a quick write-up on removing the 'crazing' you may get on your headlights over time, this will definately help you out if you see any yellow buildup or fogged lenses.
You will need:
Spray bottle for water
Wet/Dry sandpaper
320 grit (if yours were as bad as mine you'll need it)
400 grit
800 grit
1500 grit
2000 grit
Plastic Polish - I had 'Mothers'
Rag
Every item can be found at most auto stores and Walmart.
1.Spray water on the lense on give it a good sanding with your first sandpaper(320/400)
This is the main one so it will look horrible when you get first get done. Dont get crazy and press real hard, but get most of the crazing off. I moved it up and down over the entire lense, then side to side, then all around; make sure its wet the entire time.
2. Wipe all the water off, spray with water again and use your next grit.
These will buff and polish your lense back to its original clearness. Go over the entire surface again.
3.Use the same technique as your previous grits, and it will slowly get clearer.
Once you get to 2000grit youll really notice a difference, but it still wont be perfect, and it will look hazy.
4.Spray off the entire area with water and dry it good.
5.Finally, get out the plastic polish and buff away. I used a buff pad attached to a cordless drill and really worked it in.
let it dry per instructions on bottle, and wipe off.
It worked great for me. I only have one lense done for now, ill get better pictures up ASAP.
Before/After
Before/After
Threaded Mode